Before a lift truck drives into a transport trailer, what must be done to the trailer?
Forklift Operator Practice Test 3
25 questions on docks, trailers, railcars and elevators, parking, shutdown and unattended trucks, lifting people on work platforms, pre-use (circle) checks, operator competence and the law and more.
- No sign-up
- Every answer explained
- Independent · not a government site
- Set 3 of 7
- 25 questions
- Instant feedback
All 25 questions in this test
Every question and its answer choices. The correct answers and explanations appear when you take the test above.
Before a lift truck drives into a transport trailer, what must be done to the trailer?
- It must be emptied of every load before any lift truck enters
- It must be immobilized and secured against moving
- Its doors must be removed for better lighting
- It must be washed so the floor is not dusty
Which practice is never allowed when you leave the lift truck?
- Removing the key and setting the brake
- Parking it in the approved parking area
- Leaving it unattended while running or loaded
- Lowering the forks completely to the floor
Before anyone gets on a lift truck work platform, what should be done?
- A check that the platform is painted bright red
- A test drive around the warehouse at full speed
- A trial lift to check reach, mast and clearances
- A trial lift with two extra workers on board
You find a hydraulic hose dripping during the pre-use check. What should you do?
- Report it to the supervisor right away
- Wipe it dry and start your shift as planned
- Wrap it in tape and tell the next driver
- Use the truck until the drip gets worse
Manitoba's code of practice recommends retraining certified operators at what interval?
- Once, when first hired
- Every five years
- At least every three years
- Only when they change employers
You are carrying a load and must go down a ramp. How should you travel?
- Forward, with the load raised high
- In reverse, so the load stays uphill
- Sideways across the ramp, slowly
- Forward, so you can see the bottom
A pedestrian steps into your travel path. What should you do?
- Sound the horn and keep moving slowly toward them
- Raise the load so it passes over their head
- Steer around them at your normal travel speed and keep going
- Stop, lower the load and wait until the way is clear
Who else, besides operators, should be told about lift truck hazards and rules?
- Only the workplace's first aid attendants
- Only visitors who sign the guest book at the front desk
- No one, because pedestrians are not at risk
- Supervisors and workers who work near lift trucks
Under B.C.'s regulation, which maintenance records must be kept?
- Only the records of new tire purchases for the truck
- Only records of fuel used each week
- Those for work that affects safe performance
- None, if the truck is under warranty
An employer buys a used lift truck. When must its load capacity be examined?
- Only if the operator reports a problem
- Only after its first full year in service
- Never, because the seller already tested it
- Before the employer uses it for the first time
Which control is at the top (most effective) of the hierarchy of controls for lift truck traffic?
- Eliminating the hazard, such as keeping pedestrians out of truck areas
- Putting up signs that tell people to watch for lift trucks
- Training pedestrians to listen for horns and alarms
- Issuing high-visibility vests to every pedestrian working on the site
What does Ontario's regulation require about marking a lift truck's maximum load?
- It must be written only in the owner's manual kept in the main office files
- It must be plainly marked so the operator can tell the maximum load in any condition
- It must be painted on the floor of the loading dock beside each door
- It only needs to be marked on trucks bought after the year 2000
What is the deadman seat brake check?
- The brake should release when the operator sits down hard
- The horn should sound when the operator leaves the seat
- The brake should hold when the operator rises from the seat
- The lights should switch off when the seat is empty
Why should the load be kept close to the front wheels?
- It makes the forks easier to clean
- It keeps the lift truck more stable
- It lets the operator see over the load
- It allows faster travel up any ramp
At about what height should forks or a load be carried when travelling?
- Touching the floor so it cannot slide off
- About 1 m, so the operator can see under it
- As high as the overhead guard allows
- About 10–15 cm (4–6 in) above the floor
What should you check above you before lifting a load?
- The colour of the ceiling paint
- Overhead clearance, including power lines
- The air temperature near the roof
- The time on the wall clock near the dock door
An empty lift truck goes up a ramp. Which way do the forks point?
- Sideways
- Downhill
- Uphill
- It does not matter
Which description matches the Ontario law's definition of a competent person?
- Has been chosen by co-workers as the most experienced operator on shift
- Holds a certificate from any training provider, whatever the truck or the workplace
- Has worked for the same employer for at least one year without injury
- Qualified by knowledge, training and experience, knows the law and the hazards
Battery acid splashes into a worker's eye. How long should the eye be flushed with lukewarm water?
- About 2 minutes
- At least 30 minutes
- About 30 seconds
- Until it stops stinging
When must a lift truck have an overhead guard, cab or screen for the operator?
- Only when the operator is younger than 18 years old
- Only when the truck is used outdoors in rain or snow
- When the operator may be exposed to falling material
- Only on trucks that travel faster than 15 km/h on site
What sign must a personnel work platform have under Ontario's regulation?
- One showing the load that may be applied
- One showing the operator's licence number
- One showing the date the truck was built
- One showing the company's phone number
When refuelling a gasoline lift truck in Ontario, how far must ignition sources be from the dispensing point?
- At least 50 cm
- At least 30 m
- At least 3 m
- At least 1 m
What must be true of a dock plate (bridge plate) before you drive over it?
- It is newer than the trailer it is placed against for loading today
- It is designed for the loaded truck's weight and firmly in place
- It is painted yellow on at least one of its sides
- It is wider than the trailer's rear door opening
A pallet has a broken bottom runner. What should you do?
- Lift it carefully from the broken side
- Stack it at the top where it carries less
- Move it quickly before it gets worse
- Do not move it as is; the pallet is unsafe
Who may operate your lift truck while you are on a break?
- Any worker with a car driver's licence
- Only an authorized, trained operator
- Anyone who has watched you drive it
- A visitor, if a supervisor is nearby
All Forklift Operator practice tests
- Forklift Operator Mock Exam 1 – 40 QuestionsUntimed practice · answers explained
- Forklift Operator Mock Exam 2 – 40 QuestionsUntimed practice · answers explained
- Forklift Operator Mock Exam 3 – 40 QuestionsUntimed practice · answers explained
- Forklift Operator Mock Exam 4 – 40 QuestionsUntimed practice · answers explained
- Operator competence and the lawWho may drive a lift truck, what a competent person is, employer and worker duties, the right to refuse unsafe work, training records and retraining.
- Truck classes and the capacity plateThe seven lift truck classes, what the capacity (data) plate tells you, load charts, attachments and what happens to the rating when a truck is modified.
- Stability, load centre and tip-oversWhy a raised load makes the truck less stable, how speed, turns, grades and load position affect stability, counterweights, and what to do if the truck tips.
- Pre-use (circle) checksThe visual walk-around and the operational check with the key on: forks, chains, tires, fluids, battery or propane, brakes, horn, steering and lift controls, and reporting defects.
- Travelling and pedestrian safetySpeed, visibility, travelling in reverse, horns and mirrors, signallers, railway tracks, power lines, and traffic plans that keep pedestrians and lift trucks apart.
About this practice test
How many questions are in Forklift Operator practice test 3?
25 original multiple-choice practice questions covering docks, trailers, railcars and elevators, parking, shutdown and unattended trucks, lifting people on work platforms, pre-use (circle) checks, operator competence and the law, ramps, grades and surfaces, travelling and pedestrian safety, maintenance, forks and records, truck classes and the capacity plate, stability, load centre and tip-overs, picking up, carrying and stacking loads, propane, fuel and battery charging. Each answer includes an explanation. This mixed practice set does not reproduce the official exam format or predict an official score.
Are the questions the same every time?
Yes. Practice test 3 always has the same 25 questions, so you can repeat it until you get them all right. The other 6 sets use different questions.
Are these real test questions?
No. The official question bank is not published. These are original questions written from the official handbook, which is what the real Forklift Operator test is based on.